These are test results where we simulated our automation and counting program using the isotopes 12 and 13. A PC based control system together with a fast HV relay was employed to provide the extra voltage to the bouncer tube from a DC power supply. The magnets at both high and low energy ends were set for mass 13.(see MUDRA ) At the high energy end the currents were measured (from a line and an off axis FC) using a couple of current integrators. Runs #1 and #2 correspond to switching times of 4 and 8 secs with an off time of 4 secs in each case. The data shown correspond to only to 100 cycles. (Test carried out on Feb 14, 2000).